Using the hood
The hood has one variable speed motor. For the
Control devices for the grease
best performance, we recommend using the low
filter and carbon filter
speeds in normal conditions and the high
This hood has a device which warns you when
speeds in particular cases of strong odour and
to clean the grease filter or replace the carbon
vapour concentration.
filter (in the case of the air recircultion version).
We recommend starting up the hood a few
This hood is delivered without a carbon filter.
minutes before cooking and keeping it running
For this reason the warning signal to replace the
until all the odours have been eliminated.
carbon filter is not connected.
If the hood will be used for recirculation of air,
with carbon filter, the warning signal have to be
connected as follows: Press the buttons B and G
at the same time for about 3 seconds. The LED
5 MIN
01230Imarked F lights up.
FC
When the LED marked C lights up, the warning
signal is connected.
ABE F CDGHITo disconnect the warning signal, press the
buttons B and G at the same time for about 3
A - Motor OFF buttonseconds until the LED marked C goes out.
B - ON button and motor speed selection
button 1 - 2 - 3 - 1 - 2 - . . . .Grease filter saturation led
E - Speed 1 LEDThe LED marked F warns you when the grease
F - Speed 2 LED and grease filter saturationfilter needs to be cleaned.
LED (flashes)This LED flashes to warn you that the grease
C - Speed 3 LED and carbon filter saturationfilters must be cleaned.
LED (flashes)Generally, these must be cleaned after 40 hours
D - Intensive speed indicator LEDof use.
G - Intensive speed ON switchRead the maintenance instructions provided for
This speed should be used when thethe grease filters.
concentration of cooking fumes or odours
is particularly strong (for example whenCarbon filter saturation led
frying, cooking fish etc.).
The LED marked C indicates carbon filter needs
The fast speed will run for about 5 min-
to be replaced.
utes and then return to the speed previ-
This must be done after approximately 160
ously set automatically (1, 2 or 3), or
hours of use.
switch off if no speed was selected. To
Read the instructions provided for replacing the
turn off the fast speed, before the end of
carbon filter.
the 5 minutes, press bA or button utton B.
H - OFF lamp button
To restore the LED for the filter
I - ON lamp button
warnings.
After cleaning of the grease filter and exchange
If the hood fails to operate correctly, briefly
disconnect it from the mains power supply forof the carbon filter, press bA for aubout 3tton
almost 5 sec. by pulling out the plug. Then plugseconds until the LED F stops flashing.
it in again and try once more before contacting
the Technical Assistance Service.Correct ventilation
To have the cooker hood working correctly
the windows in the kitchen should be closed.
In stead a window in an adjacent room
should be open.
32 |
ACEC
