Special accessories
Active carbon filter
When the hood is used in recirculation mode an
active carbon filter should be used.
Order by the retailer
PNC 942 120 389
Installation
Unpacking
Check that the cooker hood has no damages.
Transportation damages should immediately be
reported to the one responsible for the transport
Damages, faults and eventually missing detailsMin.
should immediately be reported to the seller.Min.75 cm.
60 cm.
Take care of the packing material so that small
children cannot play with it.
Placement
The hood is to be mounted on the wall.
When installed, the hood must be not less thanFig. 2
60 cm. above electric burners or 75 cm. above
gas or mixed-fuel burners. (Fig. 2).
Mounting the chimney
Electrical connectiong.Fix the chimney support (10) with two screws
The hood has a power cord with moulded plug5 x 45 mm (11) and two wall dowels (9) on
to be connected to a wall outlet of 230 Vthe wall close to the ceiling..
The power cord length is 1,3 m.h. For exhausting version: Fit the connection
ring on the top of the hood with two screws O
3,5 x 6,5 mm (12S) then fit an axhausting
pipe long enough to reach the outside (13S).
Mounting the hood - Fig. 3For recycling version: first insert the fixing
a.Put the template onto the wall (1)and drill twonooses of the deflector (K) on the rear slot
O12mm holes (2).
b.Fit two hooks (3) on the drilled holes.(12K) then fix definitively the deflector (13K)
c.Remove the metal filters.on the top of the hood with two screws O 3,5
d.Hang the hood on the hooks and adjust thex 6,5 mm on the front holes (12K) . Check
that the active carbon filters are mounted,
position of the hood using the two screws onsee Fig. 7.
the bottom of the hooks (5).i.Prepare the electric connection (14) (see
e.On the top of the cooker hood mark tworelative chapter).
holes (6),
Remove the hood and drill two O8mm holesj.Fit the chimney (15) and fix it on the chimney
on the marked points.support with two screws 3,0 x 9 mm (16).
Fit two O8mm wall dowels (7), Hang againThe lower part of the chimney must be slided
down and inserted on the housing on the
the hood and fix the hood definitively with twoupper part of the hood (17).
screws 5X45 (8) from the inside of thehood.Remove the plastic film that protects the
f.Refit the metal filters
chimney.
k.Fit the two grids (18) on both sides of the
chimney.
5 |
ACEC
