Mounting the hood body
? Before attaching the hood body, tighten the two
screws Vr located on the hood body mounting
points.
? Hook the hood body onto the screws 12a
? Fully tighten support screws 12a
? Adjust screws Vr to level the hood body.
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney using either a flexible or rigid
pipe o 150 or 120 mm, the choice of which is left to the installer.
? To install a o 120 mm air exhaust connection,
insert the reducer flange 9 on the hood body
outlet.
? Fix the pipe in position using sufficient pipe
clamps (not supplied).
? Remove any activated charcoal filters.
RECIRCULATION VERSION AIR OUTLET
? Put connection 15 into the connection support
7.3.
? Insert the connection extension pieces laterally
14.1 in connection 15.
? Make sure that the outlet of the extension pieces
14.1 is horizontally and vertically aligned with
the chimney outlets.
? Connect the air outlet connection 15 to the hood
body outlet using either a flexible or rigid pipe o
150 or 120 mm, the choice of which is left to the
installer.
? Ensure that the activated charcoal filters have
been inserted.
GB7 |
ACEC
