Slide the appliance into the recess, pushing itDuring this operation it is not necessary to switch off
against the wall on the handle side.Athe power supply or to remove the foodstuffs.
However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried out
and it is advisable to carry out this operation when
the appliance is empty.
To carry out complete defrosting of th freezer
compartment proceed as follows:
1. pull out the plug from the wall socket or turn the
thermostat knob to the �OE setting;D023
2. remove any stored food, wrap it in several layers
of newspaper and put it in a cool place;
3. leave the door open, introduce the plastic scraper
in the appropriate seating at the bottom centre,
as shown in the diagram, place underneath a
Open the door and push the appliance against thebasin to collect the defrost water;
D068
4. when defrosting is completed, dry the interiorside of the kitchen unit opposite to that of appliance
hinges.
thoroughly;
Fasten the appliance with 4 screws provided in the
5. keep the scraper for future use;kit included with the appliance. Snap vent grille (C)
and hinge cover (D) into position.6. turn the thermostat knob back to the required
setting or replace the plug in the power socket.
DAfter letting the appliance run for at least half an
hour, replace the previously removed food into
the compartment.
D723C
Important:
Never use sharp metal tools to scrape off frost
Apply the sealing strip pushing it between thefrom the evaporator as you could damage it.
Do not use a maechanical device or any artificialrefrigerator and the adjacent cabinet.
means to speed up the thawing process other
than those recommended by the manufacturer.
A temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.
D724
Apply covers (B) on joint cover lugs and into hinge
holes.
B
D726
2219 |
ACEC
