Electrical connectionKivehetR rácspolcok
Before plugging in, ensure that the voltage andA készülék belsR falain sÃnek találhatók, melyekre
frequency shown on the serial number platetetszés szerint lehet beilleszteni a polcokat.
correspond to your domestic power supply. Voltage
can vary by ?6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
D338D338
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth inA polcok elhelyezése
compliance with current regulations, consulting a
specialist technician.
A különbözR méret1 élelmiszerek tárolásához a
The Manufacturer declines all responsibility ifajtón levR polcokat eltérR magasságokba lehet
the above safety precautions are not observed.helyezni.
This appliance complies with the following
Ehhez a következRképpen járjon el:
E.E.C. Directives:
Nyomja a polcot a nyilak által jelzett irányba, amÃg ki
- 87/308 EEC of 2/6/87 relative to radio interference
nem mozdul, majd helyezze a kÃvánt magasságra.
suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
A
Shelf holders
Your appliance is equipped with shelf retainers that
make it possible to secure the shelves duringB
transportation.
To remove them proceed as follows:
Move the shelf retainers in the direction of the arrow,
raise the shelf from the rear and push it forward untilC
it is freed and remove the retainers.
Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted in the two top
corners.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.
D594
445 |
ACEC
