Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer.
Before contacting your local Service Force Centre, please carry out the following suggested corrective actions listed below.
SymptomSolution
The machine will not startThe door has not been properly closed.
The plug is not properly inserted in the power socket.
There is a power failure.
The machine does not fill with waterEnsure the water tap is open.
Ensure the mains water supply has not been cut off.
The inlet hose may be squashed or bent. Reposition the hose.
The inlet hose may be blocked. Switch off the water supply and clean
the filter.
The dishwasher will not drainThe drain hose may be squashed or bent. Reposition the hose.
The sink may be blocked. Clear any blockages.
The drain hose extension is not correct. Follow the instructions for
connecting to the waste.
There is no vent in the end of the drain hose.
The machine is noisyDishes are rattling against each other, refer to "Loading your machine".
The spray arms are knocking against the dishes. Refer to "Loading
your machine".
The door is difficult to close The dishwasher is not level, or not properly built-in.
The filters are blockedClean the filters (refer to "Maintenance and cleaning").
The spray arms are not rotatingEnsure that the baskets have been loaded correctly. Refer to "Loading
your machine".
Visible lime deposits or white film on the dishes Check that there is salt and that the salt cap is tight.
Check that the right level of the water softener is set.
The dishes are not quite dryThe rinse aid has run out or too little is being used.
The dishes are not cleanThe baskets are too full.
(poor wash)The dishes have not been arranged properly.
The spray arms do not rotate
The spray arms are clogged.
The filters are clogged.
The filters are not in the correct position.
Not enough detergent has been used or it is unsuitable.
The detergent is old or has gone hard.
The salt container cap is not properly closed.
The washing programme selected is too gentle.
If after all these checks, the problem persists, contact yourService and spare parts
local Service Force Centre, quoting the model and serial
This product should be serviced by an authorised Service
number.
This information can be found on the rating plate located onengineer, and only genuine spare parts should be used.
Under no circumstances should you attempt to repair the
the right hand side of the dishwasher door (see picture).
machine yourself.
Repairs carried out by inexperienced persons may cause
injury or serious malfunctioning. Contact your local
Service Force Centre.
Always insist on genuine spare parts.
Prod.No. ........Ser. No. .........
Mod. ........
RA01
12 |
ACEC
