INSTALLATION
If this appliance featuring magnetic door seals isElectrical connection
to replace an older appliance having a spring lockBefore plugging in, ensure that the voltage and fre-
(latch) on the door or lid, be sure to make that
spring lock unusable before you discard the oldquency shown on the serial number plate correspond
appliance. This will prevent it from becoming ato your domestic power supply.
death-trap for a child.Voltage can vary by ?6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
LocationThe appliance must be earthed.
Place the appliance as far away as possible fromThe power supply cable plug is provided with a con-
sources of heat, e.g. radiators, heaters, direct sun-tact for this purpose.
light, etc..If the domestic power supply socket is not earthed,
The best results are achieved with a room temperatureconnect the appliance to a separate earth in compli-
ranging from +16°C to +32°C.ance with current regulations, consulting a specialist
Make sure that there is nothing at the back, at the toptechnician.
and at the bottom of the appliance to obstruct air cir-The Manufacturer declines all responsibility if the
culation.above safety precautions are not observed.
For a more efŢcient operation of the appliance the
minimum distance between the top of the applianceThis appliance complies with EEC directive
and other overhanging kitchen furniture, if any, shouldnumber 87/308 of 2/6/87 relative to radio inter-
be at least 100 mm.ference suppression.
One or more adjustable feet mounted on the base ofThis appliance complies with the following
the appliance make it possible to set it perfectly level.E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modiŢcations;
- 89/336 EEC of 3.5.89 (Electromagnetic Compatibil-
ity Directive) and subsequent modiŢcations.
Cleaning the interior
Before using the appliance for the Ţrst time, wash the
interior and all internal accessories with lukewarm wa-
ter and some neutral soap so as to remove the typical
smell of a brand-new product, then dry thoroughly.
Do not use detergents or abrasive powders, as these
will damage the Ţnish.
34 |
ACEC
