TECHNICAL SPECIFICATIONSt
The technical data is indicated in the rating plate on the left side inside the appliance.
INSTALLATION
lf this appliance featuring magnetic door seals isThis appliance complies with the following
to replace an older appliance having a spring lockE.E.C. Directives:
(latch) on the door or lid, be sure to make that
-87/308 EEC of 2/6/87 relative to radio interference
spring lock unusable before you discard the oldsuppression.
appliance. This will prevent it from becoming a
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
death-trap for a child.subsequent modifications;
- 89/336 EECof 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
Positioningmodifications.
The appliance should be installed well away from
sources of heat such as radiators, boilers, directDoor reversal
sunlight etc.
Best performance is obtained with ambient
The applianceOs door has been locked in position for
temperature between +18!C and +43!C (class T);transport by means of pins on both sides. According
+18!C and +38!C (class ST); +16!C and +32!C
(class N); +10!C and +32!C (class SN).to the door opening direction, remove relevant pins at
the top and at the bottom.
The class of your appliance is shown on its rating
plate.
For building-in and door reversibility refer to theA
relevant instructions.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plateB
correspond to your domestic power supply.
Voltage can vary by ?6% of the rated voltage.D163
For operation with different voltages, a suitably sized
auto-transformer must be used.Warning!
If the ambient temperature is cold (i.e. in
Important
The appliance must be earthed.Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting
The power supply cable plug is provided with aof the gasket or accelerate this process by
contact for this purpose.
heating up the part involved with a normal
If the domestic power supply socket is nothairdrier.
earthed. connect the appliance to a separate
earth in compliance with current regulations,
consulting a specialist technician.
The Manufacturer declines all responsibility if the
above safety precautions are not observed.
Attention!
It mustbe possible to disconnect the appliance
from the mains power supply; the plug must
therefore be easily accessible after installation.
9 |
ACEC
