132993220.qxd 11/27/02 9:21 AM Pagina 9 (Nero/Process Black pellicola)
before you press the START PAUSE button.
8 Temperature selector dial (thermostat)
If you have already pressed the START PAUSE
To select the washing temperature turn the dial to
button, and you wish to cancel the delay time,
the required value.
proceed as follows:
When your laundry is only lightly soiled, a cold wash
set the washing machine to PAUSE by pressing thecan be used (dial to position ).
START PAUSE button;
press the DELAY button once, the light relevant to
9 Programme selector dial
the selected delay goes off;
press the START PAUSE button again to start theThe selector dial is divided into 5 sections:
programme.
Cotton
Important! Synthetic
Delicate
IThe selected delay can be changed only after
selecting the washing programme again. Wool (hand washing)
IThe door will be locked throughout the delay time Special (special programmes)
(DOOR LOCKED light lit). Position O
If you need to open the door, you must first set
the washing machine to PAUSE by pressing the
START PAUSE button. After aprox. 2 minutes the
-
DOOR LOCKED light on the porthole goes off
and the door can be opened.
After you have closed the door, press the START
PAUSE button again.
-
-
The delay start can not be selected with SPIN
and DRAIN programmes.
The selector dial can be turned either clockwise or
7 Programme progress display
anticlockwise.
When you choose the delayed start, the lightPosition corresponds to the ENERGY SAVING
relevant to the selected delay lights up.programme for cotton and position O to Reset
programme/Switching OFF of the machine.
After the machine has started, the remaining time is
shown by the corresponding indicator light. At the end of the programme the selector dial
must be turned to position O, to switch the
At the beginning of the programme, only the
machine off.
WASHING light stays on. When the programme has
finished, the END pilot light comes on.ATTENTION!
If you turn the programme selector dial to another
programme when the machine is working, the lights
of the programme progress display start to flash. The
-machine will not perform the new selected
programme.
The END light flashes in the event of operating
problems :
I4 flashes: door open
I2 flashes: problem with water draining
I1 flash: problem with water supply
For more information see paragraph ?Trouble
shooting guide?.
9 |
ACEC
