132988060.qxd 09/06/2004 15:57 Pagina 20 (Nero/Process Black pellicola)
6. Emergency emptying out? Remove any objects from the pump impeller by
rotating it.
If the water is not discharged, proceed as follows to
empty out the machine:
? pull out the plug from the power socket;
? close the water tap;
? if necessary, wait until the water has cooled down;
? open the the pump door;
? place a bowl on the floor and place the end of the
emergency emptying hose into the bowl. Remove
its cap. The water should drain by gravity into the
? Put the cap back on the emergency emptying hosebowl. Whe the bowl is full, put the cap back on the
and place the latter back in its seat.hose. Empty the bowl. Repeat the procedure until
water stops flowing out;
? clean the pump if necessary as previously
described;
? replace the emergency emptying hose in its seat
after having plugged it;
? screw the pump again and close the door.
7. Frost precautions
If the machine is installed in a place where the
temperature could drop below 0°C, proceed as? Screw the pump fully in.
? Close the pump door.
follows:
? Remove the plug from the socket.
5. Water inlet filter
? Close the water tap and unscrew the water inlet
If you notice that the machine is taking longer to fill,hose from the tap.
check that the filter in the water inlet hose is not? Place the end of the emergency emptying hose
blocked.and that of the inlet hose in a bowl placed on the
Turn off the water tap.floor and let water drain out.
Unscrew the hose from the tap.? Screw the water inlet hose back on and reposition
the emergency emptying hose after having put the
Clean the filter with a stiff brush.
cap on again.Screw the hose back onto the tap.
By doing this, any water remaining in the machine is
removed, avoiding the formation of ice and,
consequently, breakage of the affected parts.
When you use the machine again, make sure that
the ambient temperature is above 0°C.
Important!
Every time you drain the water through the
emergency emptying hose you must pour 2 litres of
water into the main wash compartment of the
detergent drawer and then run the drain programme.
This will activate the ECO valve avoiding that part of
the detergent remains unused at next washing.
20 |
ACEC
