CleaningWhat to do, if ...
As required, wipe the housing and the paper fil-
ter compartment with a damp cloth. Do not use... the nozzle is hard to push
any scourers or any solvents. Occasionally vac-Reduce the power setting on the appliance.
uum the floor nozzle and brush using the crev-Cleaning efficiency is not degraded in this case.
ice nozzle.... the motor thermal cut-out is triggered
If the motor is overloaded, e.g. due to a full fil-
ter bag or blocked accessory, the thermal cut-
out shuts down the motor. In this case, switch
Paper Filter
off the appliance, unplug from the mains, and
Type: E 53leave the motor to cool down.
If you have any queries regarding the use of thisCheck paper filter bag, suction tube and suction
product or you require service then please callhose, remove any blockage.
our customer helpline on 08706 055055The appliance can be turned on again after
approximately 30 minutes.
Carrying and Storage
... the fuse has blown
The fuse may blow if you use other high power
electrical appliances on the same electrical cir-
cuit at the same time as the vacuum cleaner is
in use.
This problem may be prevented by setting the
electronic power regulator to minimum before
turning on the appliance and increasing the
power setting after switching on.
To make the appliance easier to store and carry,
slide the floor nozzle into the tool rail..
... one day the paper filter is damaged and
Parking Systemthe motor protection filter is dirty
For storing the suction pipe and nozzle duringRemove the motor protection filter, clean (tap
short pauses in vacuuming. The bracket on theout) and replace.
nozzle is slid into the parking rail on appliance.Insert new paper filter.
7 |
ACEC
