Clearance Height
The cooker hood is designed to be fitted over a
cooking appliance at the clearance heights stated,
providing the maximum output of the appliance
beneath does not exceed the maximums quoted in the
Technical Specifications.
If the output of the appliance below the cooker hood
exceeds the maximum outputs quoted, please refer toHob
the cooker manufacturers installation instructions.
A clearance height of 650mm (25 1/2 ) is requiredA: Built-in Electric Hob:650mm clearance
when installed above a built-in electric hob, or 700mmB: Built-in Gas hob:700mm clearance
(27 1/2 ) when installed above a built-in gas hob.C: Slot-in Electric Cooker: 685mm clearance
D: Slot-in Gas Cooker:787mm clearance
A clearance height of 685mm (27 ) is required when
installed above a slot-in electric cooker, or 787mm (30
1/2 ) when installed above a slot-in gas cooker.
When installed between adjoining wall cabinets, the
wall cabinets must not overhang the hob and the
distance between the underside of the cabinet and the
worktop must be 450mm. If the height of the wall
cabinet is less than 450mm, a gap of 50mm must be
maintained either side of the hob.
This cooker hood must not be installed above
a cooking appliance with a high level grill.
Fitting the Wall Brackets
1.Draw a vertical line on the wall from the centre
of the cooking appliance up to the ceiling,
using a spirit level and marking pen. This is to
ensure the correct vertical alignment of the
appliance.
2.Mark the centre positions Y for the wall bracket
keyhole fixing screws item 1 (lower fixing
bracket) at 100mm either side of the vertical
line. Ensure that the distance between the
lowest point of the hood and the cooking
appliance beneath meet the clearance
requirements quoted above.
* Clearance height as specified above
12 |
ACEC
