132993580?EW1220/1620N?gb 07/07/03 11:22 Pagina 7
Installation
7. Plug the open holes with the plugs which are
Unpacking
supplied with the instruction booklet.
All transit bolts and packing must be removed
ENGLISH
before using the appliance.
You are advised to keep all transit devices so that
they can be refitted if the machine ever has to be
transported again.
1. Using a spanner, unscrew and remove the two
rear bottom screws. Slide out the two plastic pins.
P0002
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
P0001
Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar
2. Lay the machine on its back, taking care not to
materials under the machine to compensate for any
squash the hoses. This can be avoided by
unevenness in the floor.
placing one of the corner packing pieces between
the machine and the floor.
3. Remove the polystyrene block from the bottom of
the machine and release the two plastic bags.
P1051
Water inlet
Connect the water inlet hose to a tap with a 3/4" thread.
The other end of the inlet hose which connects to the
4. Very carefully slide out the left polythene bag,machine can be turned in any direction. Simply
removing it towards the right and then downwards.loosen the fitting, rotate the hose and retighten the
5. Very carefully slide out the right polythene bag,fitting, making sure there are no water leaks.
removing it towards the left and then upwards.
P1088
P0021
The inlet hose must not be lengthened. If it is too
short and you do not wish to move the tap, you will
6. Set the machine upright and remove the
remaining rear screw from the back. Slide outhave to purchase a new, longer hose specially
the relevant pin.designed for this type of use.
7 |
ACEC
